Precautions for the use of single-punch tablet machine

Precautions for the use of single-punch tablet machine 　　 1. Before using it for the first time, you should read the manual carefully according to the actual product of the machine, and then use it.　　 2. The machine can only run in a certain direction (see the arrow on the hand wheel or the protective cover), and it cannot be reversed to avoid damage to the machine parts. Pay special attention to the adjustment of the tablet, and do not neglect.　　3. Belt tightness adjustment: It is adjusted by two adjusting nuts on the electromechanical bottom plate. Pay attention to locking after adjustment.　　4. When there is no power supply, shake the tablet by hand and remove the V-belt to reduce resistance and wear. But do not remove the large pulley, because the large pulley also has the function of saving effort by the flywheel.　　5. The rotating handle on the handwheel must be turned down when the electric tablet is pressed, so as not to hurt people during operation.　　6. u200bu200bRegardless of manual compression or electric compression, the upper punch rod should be in the rising position before starting and then start again. If it is started with the upper punch in the lowered position, it will enter the middle mold press just after the start. At this time, the inertia of the machine has not risen to the top, and it is prone to jacking. (That is, after the upper punch enters the middle mold, it 'tops to death' due to the resistance of the tablet, causing the machine to stop running. Due to the large load during jacking, it often damages the machine or burns the motor).