Precautions for the use of coating machine

Precautions for the use of the coating machine: 　　1 Attach the coating pan baffle plate according to the type of coating, install and adjust the spray device, check whether the operation, baffle plate, pot body, air blower, spray and other devices can work normally, and they will directly contact the drugs. Disinfect the parts according to the 'Disinfection Regulations for Stepless Speed u200bu200bRegulation Film Coating Machine'. 2 Loosen the speed regulating lock nut, adjust the speed of the coating pan to 4-5 rpm, stop the machine, pour an appropriate amount of tablet cores into the coating pan, and gradually increase the speed until the tablet cores can be turned well in the pan Stop acceleration at, and lock the governor wheel.　　3 Adjust the spray system to adjust the spray gun to the working pressure between 0.4-0.7Mpa, so that the atomization effect meets the coating requirements.　　4 Adjust the electric heating wire and the hot air volume of the hot air heater, so that the film sprayed on the coated tablet can be dried in time, and flammable and explosive materials should not be approached or touched by the electric furnace to prevent accidents.　　5 Work for 2-3 hours, check the soda separator, and discharge the sewage in the water storage cup.　　6 After the operation is completed, turn off the air compressor, heating wire, heater, motor, and film coating switch in turn.　　7 Follow the '× Coating Machine Cleaning Procedure' to do a good job of cleaning the film coating machine.　　8 Repair and maintain the equipment according to the coating machine maintenance program.